Speedbox 463-L / by RANGE R.A.T.S.

Speedbox... is engineered to take the misery out of mobilization, optimized for 463-L pallet fit, made to be the envy of every loadmaster, built to withstand the toughest deployment, and ready to go when you are. It’s fast. It’s easy. Load out in less than ten minutes.

Speedbox — the ten-minute mobilization system. Our rugged, roto-molded containers are lightweight, lockable, wind and waterproof, buoyant, shatter resistant, and stronger than most metals. Each capable of holding 300 lbs., Speedboxes stack and interlock to maximize secure space on a 463-L pallet. On the ground, users extend the handle to roll one Speedbox in each hand, on heavy-duty, no-flat, off-road wheel/tire assemblies. Speedbox takes the pain out of palletizing.


  • Dimensions: 34.25”L x 27.4”W x 26”D
  • Capacity: 13.8 cubic feet; 300 lbs.
  • Weight: 50 lbs.
  • Body: Single-wall, roto-molded polymer, container with integral lid; shatter resistant and stronger than most metals
  • Stackability/Interlockability: Top-to-bottom, front-to-back, and lateral engagement;  3/8-inch rope pull with cushioned grip duals as locking device between units; 3x3x3 units or 3x3x4 units load-out single 463-L pallet
  • Wheel/Tire Assembly: Ten-inch, solid polyurethane, no-flat, off-road tires; heavy-duty ball bearings and grease fittings; 5/8-inch axel.
  • Handle Mechanism: Solid 3/4-inch aluminum rod; 2-lb. solid aluminum locking block; angle iron.
  • Lock: T-handle keyed lock
  • Gasket: Built-in gasket around the top wall of each unit for airtight and watertight seal
  • Air/Water Bleed Valve/Drain: Air/water bleed valve, which doubles as a drain; cast into bottom of unit to equalize atmospheric conditions inside and out; enables ability to hold water or ice
  • Stabilizing Tethers: 3/8-inch climbing rope handle with cushioned grip; doubles as a secure interlock between units
  • Ratchet Strap Slots: Channels along sides of each Speedbox engineered to receive ratchet straps; allows unobstructed access to contents of units even while straps are fastened in place
  • Heavy-Duty Hinged Lid: Double-walled for strength and durability; reverse-cup design applies geometry to the underside for extra strength and creates an air cavity for insulation; built-in gasket provides an air/water-tight seal.
  • Heavy-Duty Compression Latches: two compression latches ensure a good seal between the body and the lid
  • Color: Black

Visit Speedbox